Cyclonic Dust Collection System
 |
This page contains historical information. It is provided for reference but does not reflect current information or policy. |
This page has been removed from search engines' indexes.
| Cyclonic Dust Collection System | |
|---|---|
| |
| Name | Cyclonic Dust Collection System |
| Zone | Wood Shop
|
| Owner | i3Detroit |
| Make Model | TBD |
| Part Number | |
| Date Acquired | 2011-07 |
| Date Departed | 2021-09 |
| Storage Location | This system is located at the north end of the wood shop. |
| Authorization Required | No |
| Status | Departed |
| Value | 650
|
| Documentation | * |
| Other References | Estimated Characteristics 10in input duct, 4,000 cfm, Peak material 500 lbs/hr, density of wood chips 17lbs/cu ft* |
Intro
For collecting dust from the wood shop.
- Main Motor Baldor
- hp=7.5, Voltage 208-230/460, Amps 21-18.8/9.4, RPM= 3450, 3 phase, 60 HZ, Service F. 1.15
- Rotary Air Lock is Tice Model VJ10x8, S/N 36299-C1127, chain driven by:
- Motor A.O. Smith Model HF27034N, 115V ac, 1 P, 3/4hp 1700 rpm with gear box
Rules
- Use with wood dust only, please!
- Turn on when using Table saw, Miter saw, Bandsaw, Sander.
- The ductwork is permanently connected to the table saw and miter saw.
- Open slide gates when using the bandsaw or sander and close when done.
- Connect with hose to planer and jointer when using these tools
Instructions
- The power switch is on ductwork down drop between the table saw and the chop saw. It is held in place with a magnet.
- Check to be sure dust/chips are falling into dust bin under airlock. If not, contact coordinator as there may be a clog.
Maintenance Info
Check Chip bin after each use, empty when 1/2 to 3/4 full, use 55gal trash bags located near machine
FAQ
- When the barrels under the sleeves feel full, empty them into the dumpster.
- Replace the plastic bag with a new one of the right size.
ToDo
purchased use New Rotary AirLock*
